Jumper Cables – A Complete Guide To Use

Jumper Cables – A Complete Guide To Use

Jumper Cables – A Complete Guide To Use

Most of the individuals are taking help from the cars to make their journey easier and enjoyable. With it, the users are required to ready for all types of situations and need to carry some basic tools to troubleshoot the normal issues. The battery-related issues are one of them and mainly these can appear with dead or worst power conditions of the battery. If you are facing issues like it then you can solve by taking help from the car with good condition and best jumper cables. The use of this particular kind of cable is not an easy task. For using it, users should follow the instructions those are mentioned in upcoming paragraphs.

Check the batteries

First of all, users are required to check out the condition of batteries of both cars. With it, the car owners are required to get proper information related to the terminals of batteries. You should identify the negative and positive terminal of both battier and point out them. The positive terminal is available with the sign of + and negative with -. By it, the identification becomes easier. Some batteries are also pointed out with colours like – red and black.

Identification of cables

After getting proper knowledge about the battery terminals, the users are required to check out the cables’ clamps. The cables are available with two phases and colours. The red colour wire or phase is used for building a connection between positive terminals of both batteries. The black coloured phase is considered for connecting the negative terminals. With it, the clamps are also stamped or represented with signs of terminals.

Build connections properly

Making connections between both cars or Duracell batteries (dead and charged) is the most important part. Here the individuals are required to take each and every step properly and wisely. If anyone does mistake in connecting the elements, then an accident may be happened due to the flow of high-voltage electricity. Firstly, users should take the positive (red) cable and connect its one end (clamp) with the positive terminal of the non-working battery. Now the second end of same cable connects with the positive terminal of fully charged or source battery. After it, you should do similar with black cable for making connections between negative terminals. When the set-up gets completed then the users are required to start the car. With it, the electricity starts flowing in the cables.

Last connection

Now the users need to place the second end of black cable to the dead car. It can be placed to any type of bolt, nut or other kinds of metal in the engine area. The users need to make sure that the metal should not be filled with oil or cover with any type of paint. With it, you should pay attention to the active parts of engine. It may harm the clamp or any type of issue may be created. This particular connection establishes for avoiding the unusual spark or any kind of hazards. In case anyone connects it to the negative terminal of dead battery then it leads to overflow of battery acid.

Start charging procedure

When the set-up is completely established after that the car owner should turn on the ignition of charged car and start it. After starting the car you should keep started it for few minutes. By it, the dead battery starts charging and gathering sufficient amount of power to start the car.

Check the dead vehicle

Now the car owner needs to check the dead car’s condition. For it, users should try to start the dead vehicles. Sometimes it will consume time and sometimes it will start immediately. If you try to start the dead vehicle more than 3 times and it does not start, then you should stop the process. In this condition, you need to give more time to the dead battery to get charged.

Dismantle the connections

When the battery charged completely and the car gets started then you should remove all connections. While removing the jumper cables, you should perform activities wisely. You need to make sure that the cables are not touching to each other and clamps are far from other connectors. After removing all things, you can enjoy the ride.